The handsets are not talking to the receiver. What do I do? (Pebble Pad Only)

• Ensure that the receiver is connected via USB cable to an available USB port and has a red

LED showing.

• Open the ClassComm software and ensure that it states “5g receiver connected” in the

bottom-left of the application

• Ensure that the handsets have the batteries inserted the correct way -

• Pressing any key should show a green communication LED. If it is red then re-map to the

receiver by pressing and holding the -/? Key until it blinks green.

• Reset the handset from the reset switch on the back and re-map to the receiver.

Please contact technical@geneeworld.com if the problem persists.